Electric push rod

Electric actuator is a new type of electric linear actuator, which is mainly composed of drive motor, reduction gear, screw, nut, guide tube, guide sleeve, actuator, mounting base, spring, shell and worm gear, micro-control switch, etc. It can realize long-distance control and centralized control. Electric push rod in a certain range of travel for back and forth movement, general electric actuator standard stroke 50, 100, 150, 200, 250, 300, 350, 400mm, special stroke can be customized according to the requirements of different application conditions. According to different application loads and design of different thrust electric actuator, generally its maximum thrust up to 6000N, no load speed 3mm ~ 45mm / s. Electric actuator with 12V/24V DC motor as a power source, there are supporting power controller, the controller's input voltage is generally 110V/220V, the output voltage of 12V/24V, powered actuator operation. Where there is power can be used, very convenient. The use of electric actuator as an actuator can not only reduce the use of pneumatic actuators required by the gas source device and auxiliary equipment, but also reduce the weight of the actuator. Electric actuators and hydraulic cylinders compared to no hydraulic source, do not need a complex set of system support, including pumps, piping, valves, filters, many joints, and so on. Therefore, from the point of view of energy saving, electric actuator actuators than pneumatic-hydraulic actuators have obvious energy-saving advantages. Electric actuator with reliable performance, sensitive action, smooth operation, push and pull the same, good environmental adaptability, etc. With the development of science and technology in modern society and the improvement of people's living standards.